

I have been using these bulbs as of late. The ones I have right now are J3 Long Neck-58 Tungsten Halogen CAPSYLITE PAR30 Long Neck Reflector Lamp Medium Base 75Watt 120Volt Wide Flood Beam. I have 75 Watt spots in the large lights and the small one are 20 Watt. These are the lights I use, they are very cheap, the 2 small ones cost $4.78 each and the 2 larger ones were $9.00 each. I have blue, gold, silver, white backdrops. The backdrops are just heavy paper that cost 84 cents each at the hobby store. I use a paper punch to punch the holes in my backdrops to hang them on. I added 3 sheet-metal screws to the top rail.

You can use the frame like it sets or on end if you need more hight. This is what it will look like when complete. Let set for a minute or so and then finish the other 3 leg in the same manor. Place the glue on the street elbow and glue it to the top frame. Install the Street Elbows on the legs but DO NOT GLUE.

The glue is not real fast so you do have time to get the part squared up with the others. Make sure you square each part with the other as you glue it. Then do one corner at a time glue the parts together. Lay all the pieces on a flat suffice and put all part together to make sure they fit. Dry fit everything together before you glue. If needed sand or file them to the correct length. Set them on end and check that all the pieces are the same length. The inside is not important but the outside should be clean and free of burrs. After you have cut all your pipe pieces you will need to clean the burrs from the ends of each pipe. The glue holds just fine without it.Ĭut all pieces that you need. I did not use the cleaner on the pipe before I glued it, I just don't plan on running any water thought it so I see no need for it.

Just remember you will need 2 pices the same size for the width and 2 of the same size for the depth. The sizes here will make a nice desktop Light Box, you can make it any size you want or need. I have used all 1/2 inch CPVC pipe and fitting on the whole project.
